A inspeção automática da máquina de bobinagem é mais importante do que a manutenção!
A máquina de corda automática faz um som muito sutil ao enrolar. Este é o som normal do fio de cobre. Quando o carregador está funcionando, o som da roda guia pode ser ouvido. Ocasionalmente, haverá um som deflacionado, mas no geral soa muito confortável. Nenhum ruído. Pessoas experientes podem julgar se há um problema pelo som da máquina de bobina.
If the screw is not tightened or needs to be installed in this area, but if the screw is not installed, the inertial impact force generated when driving the spool part will cause the part to loosen. Seriously, when the impact sound is heard, the machine must be stopped immediately for inspection. If the base is not heavy enough, or the floor is not tidy, there will be a shaking sound when the base is running; there will be a "pop" sound; there is a lack of lubricant in the bearing. As I walked around the bearing room, I heard a hissing noise. The bead on the bearing is broken, and you will hear a squeak when you drive. If the rotor parts are loose, such as the heavy screws on the cage rotor blades, or the rotor shaft, the coiler will make a knocking sound. Shaft bending and bearing wear can also cause vibration and uneven friction noise. The paint on the wires has worn out, and the two wires crossed and made a "sizzling" sound, but the wires were short-circuited. It is the electronic components that are seriously damaged.
Portanto, a inspeção e manutenção regulares são mais importantes.
